Filter
Top Products
1. Use one mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector 1 on one end of the
cable to the port 0 on the RAID card. Then, connect the mini-SAS connector 2 on the other end of
the cable to the mini-SAS ports 0-3 on the backplane.
2. If your server has more than four hard disk drives installed, use the other mini-SAS to mini-SAS
signal cable. Connect the mini-SAS connector 3 on one end of the cable to the port 1 on the RAID
card. Then, connect the mini-SAS connector
4 on the other end of the cable to the mini-SAS ports
4-5 on the backplane.
Refer to the following topics for information about the connector locations:
• “Hot-swap hard disk drive backplane” on page 27
• “RAID card” on page 25
• “System board components” on page 31
System board components
The following illustration shows the component locations on the system board.
Figure 22. System board components
1 Front panel connector 17 Riser card assembly 1 slot
2 Internal USB connector 1
18 Riser card assembly 2 slot
3 Internal USB connector 2
19 Redundant power supply connector 1
4 Intelligent Diagnostics Module connector 20 Redundant power supply connector 2
Chapter 3. Product overview 31