Filter
Top Products
20
Chapter 6: Setting up and Configuring the Router
System Summary Tab
10/100 16-Port VPN Router
Port Statistics
Click any port on the Router’s front panel image to see the status of the selected port. If the port is disabled, it will
be red; if enabled, it will be black. If the port is connected, it will be green. Information about the selected port
will appear in a separate window. The port’s Summary table will show the settings of the selected port, including
Type, Interface, Link Status, Port Activity, Priority, Speed Status, Duplex Status, and Auto negotiation. For the
selected port, the statistics table will show this information: number of packets received, number of packet bytes
received, number of packets transmitted, number of packet bytes transmitted, and number of packet errors. To
update the on-screen information, click the Refresh button. To exit this screen, click the Close button.
Network Setting Status
LAN IP. It shows the current LAN IP Address of the Router, as seen by internal users on the network, and it
hyperlinks to the LAN Setting section on the Network page of the Setup tab.
WAN IP. These show the current WAN IP Addresses for the WAN ports of the Router, as seen by external users on
the Internet. These hyperlink to the WAN setting on the Network page of the Setup tab. If a WAN port is set to
Obtain an IP automatically, two buttons, Release and Renew, will be available. Click the Release button to release
the IP address of a specific WAN port, and click the Renew button to update the DHCP Lease Time or get a new IP
address. If a WAN port is set to PPPoE or PPTP, two buttons, Connect and Disconnect, will be available.
DMZ IP. It shows the current IP Address of the Router’s DMZ port, as seen by external users on the Internet. It
hyperlinks to the DMZ setting on the Network page of the Setup tab.
Mode. It shows the Router’s Working Mode (Gateway or Router), and it hyperlinks to the Dynamic Routing section
on the Advanced Routing page of the Setup tab.
DNS. It shows all DNS Server Addresses and hyperlinks to the WAN setting on the Network page of the Setup tab.
DDNS. It shows the DDNS settings of the Router’s WAN ports and hyperlinks to the DDNS page of the Setup tab.
DMZ Host. It shows the DMZ Private Address and hyperlinks to the DMZ Host page of the Setup tab. The default is
Disabled.
Firewall Setting Status
SPI (Stateful Packet Inspection). It shows the status (On/Off) of the SPI setting and hyperlinks to the General page
of the Firewall tab.
DoS (Denial of Service). It shows the status (On/Off) of the DoS setting and hyperlinks to the General page of the
Firewall tab.
Figure 6-4: Site Map
Figure 6-5: Port Information