Filter
Top Products
Introduction
These procedures are performed on the communications system. You must complete them
after the MERLIN Messaging System module has been installed, but before you program the
MERLIN Messaging System.
Perform the following procedures to prepare the communications system prior to programming
the MERLIN Messaging System:
Assign lines to the voice ports used for Outcalling when the communications system is
configured in Key Mode.
●
Set the Outcalling lines to No Ring.●
Create a Calling Group and assign group members.●
Enable rotary signaling for MERLIN Messaging System voice ports.●
Note:
If you require more detailed information about communications system programming or
features, please refer to your communications system documentation. Communications
system programming can be performed using the system programming console or a PC
running WinSPM.
Procedures
Assigning Lines to the Voice Port Used for Outcalling in Key Mode
Setting the Outcalling Lines to No Ring (Key Mode Only)
Creating a Calling Group and Assigning Group Members
Enabling Rotary Signaling
Introduction (before programming)
http://www.sostc.com/lucent/installation/programming_communication/mmipcpmp2.htm [2/2/2000 2:32:21 PM]