Introduction
The information in this section should be used by the individual responsible for programming
the MERLIN Messaging System. All tasks described here must be performed after:
The MERLIN Messaging System module has been installed (see Installing the MERLIN
Messaging System Module).
●
The communications system has been prepared to accept MERLIN Messaging System
programming (see the introduction to Preparing the Communications System).
●
It is recommended that programming tasks be performed in a certain sequence. As you
complete a task, go on to the next task in the sequence.
Introduction (programming)
http://www.sostc.com/lucent/installation/prog_merlin_mess/overview.htm [2/2/2000 2:32:28 PM]