Filter
Top Products
Setting the Outcalling Lines to No Ring
If the communications system is operating in Key Mode and Outcalling is used, the outside line(s)
assigned to the MERLIN Messaging System voice port(s) that are used for Outcalling must be set to No
Ring. This procedure is not necessary if the communications system is operating in the Hybrid/PBX mode.
For MERLIN Messaging System Release 2 or later, the voice port(s) used for Outcalling are Port 2 on a
2-port system, Port 4 on a 4-port system, Ports 5 and 6 on a 6-port system, Ports 7 and 8 on an 8-port
system, Ports 9 and 10 on a 10-port system, or Ports 11 and 12 on a 12-port system. For Release 1 or 1.1,
the voice port used for Outcalling is Port 2 on a 2-port system, Port 4 on a 4-port system, or Port 6 on a
6-port system.
Setting the Outcalling Line to No Ring:
Step Programming Task Console Input/Selection PC Input/Selection
1 Enter programming mode
Sys Program
Exit/Start
[any key]
2 Display next page of menu /
3 Select Centralized Telephone
Programming
Cntr-Prg
4 Select Program Extension
Program Ext
5 Enter the extension you want to
program
[nnn]
Enter
[nnn]
6 Start Centralized Telephone
Programming
Start
7 Select the line/feature button
representing the Outcalling line
Press button on console
or +
function key, then
8 Select Ring Options for all lines or
ListFeature
/
/
/
Ring Options
All Lines
Enter
No Ring
or
Setting the Outcalling Lines to No Ring
http://www.sostc.com/lucent/installation/programming_communication/mmipcpmp6.htm (1 of 2) [2/2/2000 2:32:27 PM]