Filter
Top Products
9.2 Getting Ready
9
9-21
Internet Fax & Network Scan Chapter 9
*1: Required if notification of the URL is sent by e-mail.
*2: Can also be assigned automatically by the DHCP server.
*3: If there is no SMTP server available over the network, enter “0.0.0.0”
as the IP address.
9.2.2.2 Using the Control Panel To Specify Settings
Network Settings
These settings can be specified from the “NETWORK SETTINGS” menu
in Utility mode.
This section describes how to specify settings for the following functions.
● IP ADDRESS
● SUBNET MASK
● GATEWAY
● DNS CONFIG.
✎
Note
Be sure to consult your network administrator before specifying any of
the network settings.
✎
Tip
If you wish to cancel a change to a network setting before applying it,
press the [No] key. Press the [Yes] key after the message “STOP
SETTING?” appears.
PageScope Light Administrator mode: “Network” tab
FTP
Configuration
This function is
used to specify the
IP address for the
proxy server of an
FTP server.
--● - 2
Function Description
Internet
Faxing
Scan
to E-
mail
Scan to
Server
Setting
Control
Panel
PageScope
Light