Filter
Top Products
9
9.2 Getting Ready
9-32
Internet Fax & Network Scan Chapter 9
Specifying the Address for Result Notifications
1 From the “E-MAIL SETTING 2”
menu in the Utility mode, press the
[7] key on the 10-key pad to select
“REPLY ADDRESS”.
2 Enter the e-mail address to which
error notifications should be sent.
❍ For information on entering text,
refer to “Entering Text” on page 3-18.
❍ Up to 64 characters can be entered for the reply address.
❍ Normally, the reply address is set to the e-mail address of the
administrator.
3 Press the [Yes] key.
The E-MAIL SETTING 2 screen appears again.
Specifying Whether or Not To Print Header Information (“HEADER
PRINT” Function)
1 From the “E-MAIL SETTING 2”
menu in the Utility mode, press the
[8] key on the 10-key pad to select
“HEADER PRINT”.
2 Press the and keys to
select “ON” or “OFF”, and then
press the [Yes] key. The E-MAIL
SETTING 2 screen appears again.
9.2.2.3 Specifying Settings Using PageScope Light
The network settings can be specified using PageScope Light.
1 Start up PageScope Light.
❍ Refer to “Using PageScope Light” on page 9-10.
2 Log in to the Administrator mode.
3 To specify the settings using PageScope Light, click the appropriate
tab and specify the desired settings, and then click the [Apply] button.
❍ If the settings on the Network tab are modified, they are only
enabled after the [Apply] button is clicked, then the [Reset] button
next to “NIC and Printer Controller Reset” on the “System” tab is
[ ]