Filter
Top Products
Getting started > 19
The multi purpose tray can feed paper widths as small as 3.9 inches (100 mm) and lengths
up to 47.25 inches (1200 mm) for banner printing.
For paper lengths exceeding 17 inches (431.8 mm) use paper stock up to 34 lb. US Bond
(128 g/m² ) and the face up (rear) paper stacker.
Use the multi purpose tray for printing on envelopes and transparencies. Up to envelopers
or 50 sheets of transparencies can be loaded at one time, subject to a maximum stacking
depth of about 3/8” (10 mm).
Watermarked, headed paper or transparencies should be loaded print side up and top edge
into the unit. Do not use the duplex (two-sided printing) function.
Face Down Stacker
The face down stacker of the MFP can hold up to 250 sheets of 20-;b/ US Bond (75 g/m²)
standard paper and can handle paper stocks up to 47-lb. US Bond (128 g/m²). Pages
printed in reading order (page 1 first) will be sorted in reading order (last page on top,
facing down).
Face Up Stacker
The face up stacker at the rear of the unit should be opened and the tray extension pulled
out when required for use. In this condition paper will exit via this path, regardless of driver
settings.
The face up stacker can hold up to 100 sheets of 20-lb/ US Bond (75 g/m²) standard paper,
and can handle stocks up to 53-Lb. US Bond (200 g/m²).
Always use this stacker and the multi purpose feeder for paper stocks heavier than 47-lb.
US Bond (176 g/m²).
Duplex Unit
The duplex unit provides automatic two-sided printing on the same range of paper sizes as
tray 2 (i.e. all cassette sizes except A6), using paper stocks from 17 to 28-lb. US Bond
(64-105 g/m²).