Filter
Top Products
Configuring Your Machine > 54
Print Setup
(cont.)
EPSON FX
Setup
(cont.)
Form Length 11.7 Inch, 11 Inch,
12 Inch
Specifies the length of paper.
TOF Position 0.0 Inch - 1.0 Inch Specifies the distance of print from
the top edge of the paper.
Left Margin 0.0 Inch - 1.0 Inch Specifies the distance of print from
the left hand edge of the paper.
Fit to Letter Enable, Disable Sets the printing mode that can fit
print data, equivalent to 11 inches
(66 lines), in the LETTER-size
printable area.
Text Height Same, Diff Sets the height of a character.
SAME: Regardless of CPI,
same
height
DIFF: As CPI, character heights
vary.
Cont Paper
Mode
OFF, ON If you have multiple feed trays
installed in which the media is the
same size and type you can enable
continuous paper mode. When one
tray runs out of paper, the unit will
switch to another tray.
Network
Menu
Network
Setup
TCP/IP Disable, Enable Enables or disables this network
protocol.
IP Version IPv4, IPv4 + IPv6 Set up the IP version.
Display condition: TCP/IP protocol
must be enabled.
NetBEUI Disable, Enable Enables or disables this network
protocol.
NetBIOS over
TCP
Disable, Enable En
ables or disables this network
protocol.
Display condition: TCP/IP protocol
must be enabled.
NetWare Disable, Enable Enables or disables this network
protocol.
EtherTalk Disable, Enable Enables or disables this network
protocol.
Frame Type Auto, 802.2, 802.3,
ETHERNET II, SNAP
Selects the Ethernet MAC layer
frame type.
Display condition: Netware must
be enabled.
IP Address Set Manual, Auto Specifies whether IP address
allocation is automatic (DHCP) or
manually assigned.
Display condition: TCP/IP protocol
must be enabled.
IPv4 address xxx.xxx.xxx.xxx Current assigned IP address.
To change, enter the address
using the numeric
al keypad. Press
Enter to register new address.
Display condition: TCP/IP protocol
must be enabled.
FEATURE OPTION DESCRIPTION