Filter
Top Products
1.13
Getting started
Adjust the monitor speaker’s volume
You can set the volume of the monitor speaker, assuring that on-hook dialing will be
as loud (or as soft) as you require.
1
Press
MONITOR
/
CALL
on the control panel. You now should hear a dial tone,
and the display will show:
Important: If you don’t hear a dial tone, make sure your fax machine is
plugged into a working phone line.
2
If the volume you hear is satisfactory, skip to step 4.
Otherwise, proceed to step 3.
3
Adjust the volume as you wish:
To turn the volume up, press .
To turns the volume down, press .
The LCD indicates the volume. Here are the possible settings:
= Loudest setting.
= Medium setting.
= Low setting.
= Volume off.
4
Press
MONITOR
/
CALL
again to hang up.
Attaching an optional handset
You may purchase an optional handset for your fax machine. Here is how to attach
the handset.
Important: Do not connect the handset directly to a telephone wall jack. Instead,
connect it only to your fax, as these instructions describe.
1
Remove the two screw caps and screws.
2
Using a Phillips-head screwdriver,
attach the handset cradle to the rear
side of your machine, using the screws
included with the cradle.
3
Plug one end of the handset cord (it’s
curled) into the
PHONE
1 jack on the left
of your machine.
4
Plug the other end of the handset cord
into the jack on the handset. If con-
nected to a phone line, your fax machine
is now “off-hook.”
Note: The handset has a small “flash”
button which you can press
while holding the handset,
putting the fax machine back
“on-hook” until you can hang up
the handset properly in step 5.
** Tel Mode **
Volume:
** Tel Mode **
Volume:
■■■■
** Tel Mode **
Volume:
■■■■
■■■■
** Tel Mode **
Volume:
■■■■
■■■■
■■■■
** Tel Mode **