Filter
Top Products
Installation and Basic Configuration
26
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
Figure 13.
2. Configure the IPv4 settings as explained in the following table:
3. Click Apply
to save your settings.
Table 4. IPv4 settings
Setting Description
DHCP Client By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If
you have a DHCP server on your LAN and you select the Enable check box, the
wireless access point receives its IP address, subnet mask, and default gateway
settings automatically from the DHCP server on your network when you connect
the wireless access point to your LAN.
IP Address Enter the IP address of your wireless access
point. The default IP address is
192.168.0.100. To change the address, enter an unused IP address from the
address range used on your LAN, or enable DHCP the server.
IP Subnet Mask Enter the network number portion of an IP ad
dress. Unless you are
implementing subnetting, enter 255.255.0.0 as the subnet mask.
Default Gateway Enter the IP address of the ISP gateway to wh
ich the wireless access point
connects.
Primary DNS Server
Enter the IP address of the primary and
secondary DNS servers.
A DNS server is a host on the Internet th
at translates Internet names (such as
www.netgear.com) to numeric IP addresses. Typically your ISP transfers the IP
address of one or two DNS servers to your wireless access point during login. If
the ISP does not transfer an address, you need to obtain it from the ISP and
enter it manually in this field.
Secondary DNS Server
Network Integrity Check Select this check box to validate that the up
stream link is active before allowing
wireless associations. Ensure that the default gateway is configured.