Filter
Top Products
Installation and Basic Configuration
31
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
6. Click Apply to save your settings and enable the selected wireless mode.
Note: For information about how to configure advanced wireless settings,
see Configure Advanced Wireless Settings on page 107.
Configure 802.11a/na Wireless Settings
To configure the 802.11a/na wireless settings:
1. Select Con
figuration > Wireless > Basic > Wireless Settings. The basic Wireless
Settings screen displays. (The following figure shows the 802.11na settings.)
Note: The radio wave icon ( ) displays next to the selected radio mode.
11b and 11bg modes
only
Data Rate From the drop-down list, select the transmit data rate of the
wireless network. The default setting is Best. For a list of all
options that you can select from in 11b mode and 11bg mode,
see Factory Default Settings on
page 142.
Output Power From the drop-down list, select the transmission power of the wireless access
point: Full, Half, Quarter, Eighth, Minimum. The default is Full.
Note: Increasing the power improves performance
, but if two or more wireless
access points are operating in the same area and on the same channel,
interference can occur.
Note: Make sure that you comply with the regu
latory requirements for total radio
frequency (RF) output power in your country.
Table 6. Basic 2.4 GHz band wireless settings (continued)
Setting Descriptions