Filter
Top Products
112
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Plug the unit into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio television techni-
cian for help.
A properly shielded interface cable must be used in order to
ensure compliance of this equipment with FCC regulations.
Changes or modifications not expressly approved by Oki Data
may void your authority to operate this device.
230/240-Volt Models
WARNING: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
It is the responsibility of the user to obtain the required shielded
cable in order to ensure compliance of this equipment with FCC
regulations.
Changes or modifications not expressly approved by Oki Data
may void your authority to operate this device.
Industry Canada (IC)
Requirements for End Users
“This product meets the applicable Industry Canada technical
specifications.”
Before installing this equipment, users should ensure that it is
permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some
cases, the company’s inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord). The customer
should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines and