Filter
Top Products
54
• When Part. is selected, the common header of the first page is
added in original size.
• When Whole is selected, the first page is added at a reduced
size.
05: SENDER ID: This function controls the printing of the
Sender ID of your fax machine on the faxes you send. When
turned on, your Sender ID, date and time will be printed on each
page slightly outside the image area of your document. When
turned off, your Sender ID, date and time will not be printed.
However, some fax machines will print your TSI/CSI.
06: MONITOR VOLUME: This function sets the volume your
fax machine uses for telephone line monitoring sounds during
dialing. Available settings are Off, Low, Middle, High Middle
and High.
07: BUZZER VOLUME: This function sets the volume of the
various beep and alarm tones your fax machine emits during
operations. Available settings are Low, Middle and High.
08: CLOSED NETWORK: This function allows you to program
your fax machine to refuse to receive faxes from or transmit
faxes to locations whose telephone numbers have not been
programmed into the One-Touch keys or Auto Dial numbers of
your fax machine. Using this function, you can set up a closed
network of fax machines. If you do not want your fax machine to
transmit faxes to or receive faxes from locations outside your
network, select T/R. If you only want your fax machine to refuse
to receive faxes from outside your network, select RX. Available
settings are OFF, T/R and RX.
09: TX MODE DEFAULT: This function allows you to change
default type of original, transmit and copy resolution settings of
your fax machine. Unless you select otherwise using the
Transmit Resolution/YES or Type of Original/NO keys, your fax
machine is set to use the STD and NORMAL settings. If you are
constantly sending faxes, which require some other combination
of transmission modes, use this function setting to change the
default transmission modes to any other combination of settings.
While you are programming, the new default combinations will
appear on the LEDs above the Transmit Resolution/YES or Type
of Original/NO keys.
10: T/F TIMER PRG.: When set to the telephone/ fax answering
mode, your fax machine automatically distinguishes between
incoming voice and fax calls. If the incoming call is a voice call,
your fax machine will ring to tell you to pick up the handset. If
you do not answer, your fax machine automatically switches
back to facsimile mode to allow the calling party to send a fax.
The T/F TIMER function controls how long your fax machine
waits before switching back to fax mode. Available settings are
20 seconds or 35 seconds.
11: RING RESPONSE: This function controls how long your
fax machine waits before answering an incoming telephone call
when your fax machine is set to auto receive or telephone/fax
auto switch answering modes. The available settings are 1 ring, 5
seconds, 10 seconds, 15 seconds or 20 seconds.
Note: If your fax machine is set to telephone/fax auto switch
answering mode, it is recommended that you set ring
response to one ring.