Filter
Top Products
141
This section will describe what you should take notice when using a PS·Data system controller.
The same descriptions as the system controller's operating instructions are not mentioned here. Refer to them.
■ Controlling the Recorder with a PS·Data System Controller
● Recorder Mode
Before operating the recorder, it is necessary to enter the recorder mode.
1. Select the desired monitor. (Refer to p. 125 Monitor Selection.)
2. In the PS·Data mode, a number is assigned to each recorder. To select a desired recorder, enter the corresponding num-
ber by pressing the numeric buttons.
Recorder Number
Master recorder 100
Slave 1 recorder 101
Slave 2 recorder 102
Slave 3 recorder 103
Slave 4 recorder 104
3. Press the CAM button.
The recorder image will be displayed on the selected monitor, and you will enter the recorder mode.
● Operations
1. Press the SHIFT button to activate the FUNCTION buttons.
2. Enter the desired function code, and then press the FUNCTION button. (Refer to the diagram.)
3. To select a camera channel, press the numeric button(s), then CAM button. The system will exit from the recorder mode,
and the selected camera image will be displayed on the monitor.
Notes:
• Only one operator can enter the recording mode.
• The images from the recorder, which are displayed on the monitor, is conformed to the recorder setting.
• You cannot skip to the previous/next record by moving the joystick.
Exclusive use to stop recording
WJ-HD500 SERIES CONTROL (PS·DATA)
Function Code
Note
Forward field advance 1 Available only during pause
Backward field advance 2 Available only during pause
Pause 4
Playback 5
Recording 6 Equal to the REC button of the recorder
Stop recording and playback 8
Stop playback 9 Exclusive use to stop playback
Stop recording 10
Search forward 11
Search backward
Displaying a recorder's OSD
12
19
Pressing again will hide the display.