Filter
Top Products
63
WJ-SX150A SETUP MENU (OSD)
The WJ-SX150A SETUP MENU (SETUP MENU) enables
function controls that are not available by direct operation.
Note: Only one operator can enter SETUP MENU.
■ Displaying SETUP MENU
To display SETUP MENU, follow the procedure below.
1. Confirm that the camera and peripherals are correctly
and securely connected and that all components are
turned on.
2. To execute the selection, select one of the monitors (1
to 4) by pressing the numeric button, then press the
MON (ESC) button.
The MONITOR indicator will light up.
3. Press the SETUP button while holding down the SHIFT
button on the system controller.
WJ-SX150A SETUP MENU will appear on the active
monitor as shown below, and the system controller's
SETUP indicator will light up.
The tree of SETUP MENU is shown in the next page.
Note: “x.xx” in SETUP MENU shows the firmware ver-
sion.
The following functions and buttons are valid in SETUP
MENU:
Joystick to UP(D): Moves the cursor up or returns to
the previous page.
Joystick to DOWN(C): Moves the cursor down or dis-
plays the next page.
Joystick to L(A): Moves the cursor to the left.
Joystick to R (B): Moves the cursor to the right.
PREV button: Selects the previous mode or parameter.
NEXT button: Selects the next mode or parameter.
Numeric buttons: Enters numerals.
CLEAR button: Deletes a character when editing a
camera title.
CAM (SET) button: Executes the selections and dis-
plays a submenu for items with the (O) mark.
MON (ESC) button: Returns to SETUP MENU or the
previous menu.
This operating instructions uses the symbols to
describe the buttons.
4. To end the setting and return to the normal view, press
the SETUP button while holding down the SHIFT button
when SETUP MENU is displayed.
The system controller's SETUP indicator will go off.
■ Programming SETUP MENU
As shown in the tree, SETUP MENU has 10 submenus:
TIME & DATE, D. S. T., SEQUENCE, ALARM, CAMERA
TITLE, RECORDER, SYSTEM, OPERATOR REGISTRATION,
MULTIPLEXER, and MUX CAMERA TITLE. The submenus
except TIME & DATE and D. S. T. are divided into addition-
al submenus.
The (O) mark indicates that the item has a submenu for
more detailed setups.
Refer to the figure in p. 65 for the composition of SETUP
MENU.
SETUP
SHIFT
WJ-SX150A SETUP MENU x.xx
100 TIME&DATE Aug/21/2002 10:55 AM
200 D.S.T. ON
300 SEQUENCEO
400 ALARMO
500 CAMERA TITLEO
600 RECORDERO
700 SYSTEMO
800 OPERATOR REGISTRATIONO
900 MULTIPLEXERO
1000 MUX CAMERA TITLEO
* This is the factory default setting.