Filter
Top Products
144
This section will describe what you should take notice when using a PS·Data system controller.
The same descriptions as the system controller's operating instructions are not mentioned here. Refer to them.
Note: Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the
digital disk recorder, and configure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and WJ-
HD100 Series SETUP MENU. [Refer to p. 32 Installing the Multiplexer Board, p. 45 Connection with Digital Disk Recorder
WJ-HD100 Series, p. 63 WJ-SX150A SETUP MENU (OSD), p. 79 WJ-SX150A ADMINISTRATOR CONSOLE, and p. 137
Displaying WJ-HD100 Series SETUP MENU.]
■ Controlling the Recorder with a PS·Data System Controller
● Recorder Mode
1. Enter the recorder mode. (Refer to p. 141.)
2. Press the SHIFT button to activate the FUNCTION buttons.
3. Enter the desired function code, and then press the FUNCTION button. (Refer to the diagram.)
4. To select a camera channel, press the numeric button(s), then CAM button. The system will exit from the recorder mode,
and the selected camera image will be displayed on the monitor.
Notes:
• Only one operator can enter the recorder mode.
• The images from the recorder, which are displayed on the monitor, is conformed to the recorder setting.
● Stopping REC ONLY Alarm Recording
The operations are the same as WJ-HD500 Series. Refer to p. 142.
WJ-HD100 SERIES CONTROL (PS·DATA)
MUX
Function Code Note
Forward field advance 1
Backward field advance
To the last field
Pause
Playback
Recording
To the first field
Stop recording and playback
Stop playback
Stop recording
Search forward
Search backward
2
3
4
5
6
7
8
9
10
11
12
Equal to the REC button of the recorder
Exclusive use to stop playback
Exclusive use to stop recording
Searching will speed up every time you enter the code.
Searching will speed up every time you enter the code.