Filter
Top Products
24
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
■ WJ-SX150A Matrix Switcher
● Front View
q Operation indicator (OPERATE)
Lights up when the power of the unit is turned on.
Note: The indicator will blink to indicate rising tempera-
ture in the matrix switcher.
When the indicator blinks, turn the power off and
refer servicing to qualified service personnel.
w Reset button (RESET)
Resets and restarts the unit.
Note: The system configuration is not reset.
e Unit number selector (UNIT)
Normally, set this selector to “0”.
When applying the master-slave connection, set this
selector to one of the following unit numbers. (Refer to
pp. 49 to 55 for details on the master-slave connection.)
Master/Slave Unit number
Master 0
Slave 1 1
Slave 2 2
Slave 3 3
Slave 4 4
r Mode selector (MODE)
Selects the unit's operation mode.
Normally, set all switches to OFF (NORMAL mode) as
shown in the figure.
SX150A SOFTWARE UPLOAD:
Set the switches to this position when you update
the firmware of the unit. (Refer to the operating
instructions of the Multiplexer board.)
MULTIPLEXER SOFTWARE UPLOAD:
This mode is reserved for future use.
Matrix Switcher WJ-SX A
OPERATE
OPERATE LED WILL BLINK
IF COOLING FAN MALFUNCTIONS
q
0
9
8
7
6
5
4
3
2
1
MODEUNITRESET
we r
1
ON
234
1
ON
234
1
ON
234
1
ON
234
NORMAL
SX150
SOFTWARE UPLOAD
MULTIPLEXER
SOFTWARE UPLOAD
MODE SW SETUP