Panasonic WJ-SX150A Switch User Manual


 
150
Initializing…” is displayed on monitors.
(For WJ-HD500 Series recorders) You
cannot search for records even when car-
rying out the Search Playback procedure.
Recording or playback with the recorder
is not correctly carried out.
NOT ASSIGN is displayed beside the
camera number on the monitor.
The alarm mode is not activated.
The alarm mode is set to OFF. Set the alarm mode to SEQUENCE or
HOLD in SETUP MENU or WJ-SX150A
Administrator Console.
SETUP MENU: Refer to p. 67.
Administrator Console: Refer to p. 88.
The port for an alarm input is set to
OFF.
Set the alarm port to ON in SETUP
MENU or WJ-SX150A Administrator
Console.
SETUP MENU: Refer to pp. 68 to 69
Administrator Console: Refer to p. 88.
When "ALM SUSPENDED" is displayed
on the monitor, the alarm is suspended.
Press the ACK/SUSPEND button while
holding down the SHIFT button to can-
cel the alarm suspension.
SETUP MENU may be open. Press the SETUP button while holding
down the SHIFT button to close SETUP
MENU.
ACK or RESET is not activated. You may not have selected the alarm-
related monitor.
Select the monitor again. (Refer to pp.
106 or 125.)
The system controller is not authorized
to select the monitor.
Confirm the Monitor Selection window in
WJ-SX150A Administrator Console and
reconfigure the setting if necessary.
(Refer to p. 92.)
You are not authorized to reset an
alarm.
Confirm the Level Table window in WJ-
SX150A Administrator Console and
reconfigure the setting if necessary.
(Refer to p. 91.)
While the PROHIBITED indicator is
lighting on the system controller, you
are prohibited to control the monitor.
Open the Monitor Selection window
(refer to p. 92) and reconfigure the set-
ting if necessary.
Timer event is not activated.
A higher-priority operator may have
selected the event-related monitor.
Select another monitor.
SETUP MENU does not open.
When the PROHIBITED indicator is light-
ing on the system controller, you are pro-
hibited to open SETUP MENU.
Open the Level Table window (refer to
p. 91) and reconfigure the setting.
The system does not enter the recorder
mode.
The recorder connection may be
wrong.
Connect the recommended recorder to
the unit.
The connected recorder may not con-
form to the unit.
Confirm the recorder connection (refer
to pp. 40 to 47.)
You are not authorized to operate the
recorder.
Open the Level Table window (refer to
p. 91) and reconfigure the setting.
Problem Check item Remedy
When you select the LCN (logical cam-
era number) not assigned in the system,
NOT ASSIGN will appear.
Select an assigned logical camera num-
ber. (Refer to p. 107.)
If connections or settings are wrong, this
message, SLAVE n*, and the firmware
version will be displayed after you turn
on a Slave recorder.
*n is a unit number.
Error or TIME OUT may be displayed
after pressing the PLAY button in the
date-and-time entry form.
Camera number settings are wrong.
Confirm the connections (refer to pp. 33
to 55) and settings (refer to pp. 57 to
102).
The date-and-time entry form is unavail-
able. Use Record List or Thumbnail
Display to search for records.
Conform the LCN (logical camera num-
ber) settings of the unit and camera
number settings of the recorder.