Filter
Top Products
COMSPHERE 3800Plus Modems
13-6 November 1996 3980-A2-GB30-20
Table 13-1
(4 of 11)
3800
Plus
AT Commands
AT Command Front Panel BranchDescription
X
n
Extended Result Code, Dial Tone Detect, and Busy Tone Detect
Configuration Options
Dial Busy
Extended T
one
Tone
Result Code Detect Detect
X0 Disable Disable Disable
X1 Enable Disable Disable
X2 Enable Enable Disable
X3 Enable Disable Enable
X4 Enable Enable Enable
X5 Add/EC Enable Enable
X6 Add/V42,MNP Enable Enable
X7 Use DTE Rate Enable Enable
Extended Result Code
Enable. Displays all result codes listed in Appendix B except for error
control suffix.
Disable. Only displays OK, CONNECT, RING, NO CARRIER, ERROR.
Add/EC. Displays result codes with /EC suffix. Add/V42,MNP. Displays
result codes with either V.42 or MNP suffix. Use DTE Rate.
Displays DTE data rate instead of line rate.
Add/V42,MNP. Displays result codes with either V.42 or MNP suffix.
Use DTE Rate. Displays DTE data rate instead of line rate.
Extended Result Code:
Configure\Edit\DTE Dialer
Dial Tone Detect:
Configure\Edit\
Line Dialer
Busy Tone Detect:
Configure\Edit\
Line Dialer
Dial Tone
Detect
Enable. Sets the modem for dial tone detect.
Disable. Sets the modem for blind dialing.
Busy Tone Detect
Enable. Modem monitors for busy tone.
Disable. Modem ignores busy tone.
Y
n
Long Space Disconnect
Y0 Disable. Ignores long space.
Y1 Enable
.
Disconnects if long space is detected. Enables
transmission of a long space.
Configure\Edit\
Line Dialer
Z
n
Reset and Load Active
Z0 Loads configuration options from Active (Saved) to Active
(Operating).
Z1 Loads configuration options from Customer 1 to Active (Operating).
Z2 Loads configuration from Customer 2 to Active (Operating).
Z3 Loads configuration options from Active (Saved) to Active
(Operating) and performs a reset (if the modem is connected, it is
disconnected).
Z9 Performs a full modem reset, as if the power were turned of
f and
on.
Control\Reset