Filter
Top Products
Configure Branch
8-413980-A2-GB30-20 November 1996
Table 8-8
(3 of 3)
Miscellaneous Configuration Options
NMS_Call_Msgs: CallCnct&Prg
Nxt CallCnct&Prg Disable CallCnctOnly CallProgOnly
NMS Call Messages. Determines if modem status and/or call summary information is sent to the 6700 Series NMS. The
modem can itemize status, such as CallProgress messages, or it can report a summary of activity, such as Call Connect
messages, to the NMS.
Call Connect & Progress – Enables both Call Connect and Call Progress information to be reported to the NMS.
Disable – Modem status and call summary information is not sent to the NMS.
Call Connect Only – The modem accumulates call statistics over a period of time and then reports these statistics to
the NMS. The NMS uses this data to produce utilization reports.
Call Progress Only – The modem reports detailed modem status information to the NMS. These messages include any
events that can display on the LCD.
The factory default templates do not affect NMS Call Messages.
AT command equivalent is S66=
n
.
NMS DTR Alarm: Disable
Nxt Disable Enable
NMS DTR Alarm. Determines whether an NMS DTE alarm report is generated when DTR is off.
Disable – The state of DTR does not cause an alarm condition to be reported.
Enable – A DTE alarm condition is reported to the NMS controller in the Device Health & Status message if DTR is off
for more than 10 seconds. The alarm condition is reported as inactive after DTR is on for 3 seconds.
The factory default templates do not affect NMS DTR Alarm.
AT command equivalent is S77=
n
.
NetworkPosition: Tributary
Nxt Tributary Control
Network Position Identification. Each modem must be identified either as a control modem or a tributary modem.
NOTE: This configuration option is only applicable for leased-line network management applications.
For the 3810
Plus
and 3820
Plus
, Tributary is the factory default.
For the 3811
Plus
, Control is the factory default.
AT command equivalent is S74=
n
.
CellulrRJ11Adpt:: Disable
End Disable Enable
Cellular RJ11 Adapt. Allows the modem to support an RJ11 connection to a 3-watt phone. It also causes the modem to
transmit the ETC 1.1 Calling T
one during call origination.
Disable – No RJ11 support or ETC 1.1 Calling Tone.
Enable – For use when the Cellular(Mobile) factory template is loaded, enables RJ11 support and ETC 1.1 Calling Tone.
AT command equivalent is S93=
n
.