Filter
Top Products
COMSPHERE 3800Plus Modems
13-22 November 1996 3980-A2-GB30-20
Table 13-2
(9 of 13)
3800
Plus
S-Registers
AT Command Front Panel BranchDescription
S62 V.25bis Coding
Register identifies to the modem the type of coding used by the DTE while
in V.25bis mode.
Register has the following values:
0=ASCII
1=EBCDIC
Factory setting is ASCII.
Configure\Edit\
DTE Dialer
S63 V.25bis Idle Character
Register identifies to the modem the type of idle fill used by the DTE while
in V.25bis mode.
Register has the following values:
0=Mark
1=Flag
Factory setting is Mark.
Configure\Edit\
DTE Dialer
S64 V.25bis New Line Character
Register identifies to the modem the type of line terminator used by the
DTE while in V.25bis mode.
Register has the following values:
0=Carriage Return and Line Feed
1=Carriage Return
2=Line Feed
Factory setting is carriage return and line feed (CR + LF).
Configure\Edit\
DTE Dialer
S66 NMS Call Messages
Register determines if the modem sends information regarding status (Call
Progress) and/or sends summarized call statistics (Call Connect) to the
dial network management system (COMSPHERE 6700 Series NMS).
Register has the following values:
0=Call Connect & Progress
1=Disable
2=Call Connect Only
3=Call Progress Only
The factory default templates do not affect S66.
Configure\Edit\Misc
S67 Directory Location 1 Callback
Register determines if the modem uses the single number callback
function.
Register has the following values:
0=Disable
1=Enable
Factory setting is Disable.
Configure\Edit\Misc
S69 Make Busy Via DTR
Register determines if the modem goes off-hook (busy) when DTR is Off.
Register has the following values:
0=Disable
1=Enable
Factory setting is Disable.
Configure\Edit\
Line Dialer