Filter
Top Products
COMSPHERE 3800Plus Modems
8-16 November 1996 3980-A2-GB30-20
Table 8-2
(3 of 5)
DTE Dialer Configuration Options
*Backspace Char: 008 ASCI
Nxt ↑ 008 ASCI
Backspace Character. Sets the character used to perform a backspace in Command mode.
The factory default is 08 (ASCII backspace character).
AT command equivalent is S-register S5=
n
.
*Linefeed Char: 010 ASCI
Nxt ↑ 010 ASCI
Line Feed Character. Sets the character used to perform a line feed in Command mode for responses from the modem.
The factory default is 10 (ASCII line feed character).
AT command equivalent is S-register S4=
n
.
*Result Codes: Enable
Nxt Enable Disable EnableInOrig
Result Codes. Result codes are informational messages (such as Connect and Ring) sent from the modem and
displayed on the asynchronous DTE terminal. (For a list of Result Codes, refer to T
able 1
1-1 in Chapter 1
1,
AT Commands and S-registers.
)
Enable – Modem sends result codes to the DTE.
Disable – Modem does not send result codes to the DTE.
EnableInOrig – For UNIXr applications, enable result codes only on the originating modem. This prevents the DTE on
the answer side from interpreting result codes as login attempts.
For Async Dial, Enable is the factory default.
For UNIX Dial, EnableInOrig is the factory default.
AT command equivalent is Q
n
.
*ExtendResltCode: Enable
Nxt Enable Disable Add/EC Add/V42,MNP Use_DTE_Rate
Extended Result Codes. Informational messages such as VF data rate and Error Control are displayed with the result
codes. (For a list of Extended Result Codes, refer to T
able 1
1-1 in Chapter 1
1,
AT Commands and S-registers
.)
Enable
–
NO DIALTONE, BUSY, NO ANSWER
, and
CONNECT xxxx (xxxx = VF data rate) are displayed along with
result codes listed in T
able 1
1-1 in Chapter 11.
Disable – Only OK, CONNECT, RING, NO CARRIER,
and
ERROR result codes appear.
NOTE: NO DIALTONE is valid only if Dial Tone Detect configuration option is enabled. BUSY appears if Busy Detect
configuration option is enabled.
Add/EC – Places the EC suffix after the result code text if error control is used. For example, CONNECT 9600/EC
Add/V.42, MNP – Places either the /V.42 or /MNP suffix after the result code text if data compression is used. For
example, CONNECT 9600/V42b.
Use DTE Rate – Allows the DTE rate to be displayed in the Connect message instead of the line rate. This feature is
required in some modem pooling applications.
The factory default is Enable.
AT command equivalent is X
n
.
* This configuration option only appears if DTE Dialer Type is configured for AT.