Filter
Top Products
Call Setup Branch
5-33980-A2-GB30-20 November 1996
F1
Disconnect
Command Complete
F2
F3
The modem goes on-hook (hangs up) and the call is
disconnected. This includes any calls being used for dial
backup of leased lines. The
Command Complete
status
message is displayed.
To exit this function and remain in the Call Setup
branch, press the
key
. To exit and return to the
Top-Level menu, press the
key
.
AT Command Equivalent
The
A
T command equivalent for Disconnect is H or
H0.
Answer
Answer allows the modem to go off-hook, generate an
answer tone, and begin the handshaking process with the
calling modem. Use the Answer function when the
Auto-Answer Ring Count configuration option is
disabled. (See the
Line Dialer section in Chapter 7,
Configur
e Branch
.)
T
o access Answer from the Call Setup branch, make
the following selections:
F1
Call Setup:
Answer
F2
F3
Press the
key until Answer is displayed. Select
Answer.
F1
Answer
Command Complete
F2
F3
The modem goes of
f-hook and attempts to establish a
connection in Answer mode. The Command Complete
status message appears on the LCD.
To exit this function and remain in the Call Setup
branch, press the
key
. To exit and return to the
Top-Level menu, press the
key
.
AT Command Equivalent
The
A
T command equivalent for Answer is A.
Dial Standby/Return to Dial
The Dial Standby and Return to Dial functions appear
on the LCD only after the modem, operating on leased
lines, is placed into dial backup. Once the modem is
operating in Dial Backup mode, these functions allow the
modem to be switched back and forth between dial and
leased-line operation while still maintaining the dial
connection. See Figure 5-1. (Switching between dial and
leased-line operation can be performed manually or
automatically by enabling the Auto Dial Standby
configuration option.)
496-13081-01
MODEMMODEM
LEASED-LINE
FAILURE
XX
DIAL BACKUP LINE
DIAL
STANDBY
RETURN
TO DIAL
Figure 5-1. Dial Backup