Filter
Top Products
COMSPHERE 3800Plus Modems
5-2 November 1996 3980-A2-GB30-20
Call Setup Branch
In
the following descriptions, the shaded key indicates
what key to press to perform the described operation.
To access the Call Setup branch from the Top-Level
menu, select Call Setup:
F1
Idle: 28.8 >
Call_Setup
F2
F3
Dial
Dial allows you to dial any telephone number stored in
directory locations 1–10. Any telephone number dialed
using the DCP must already exist in a directory location.
Refer to Change Directory for information on storing
telephone numbers in directory locations.
T
o access Dial from the Call Setup branch, make the
following selection:
F1
Call Setup: >
Dial Disconnect
F2
F3
Select Dial to display the first directory telephone
number.
F1
Dial Directory:
Nxt 01:5551234
F2
F3
To view other directory locations, select Nxt.
F1
Dial Directory: 01
Dialing
F2
F3
Once the directory location you want appears on the
LCD, press the F2 or F3 key to dial the number.
If the connection is successful, the modem is online
and one of the Normal Operation status messages appears
on the LCD. If the connection is not successful, the LCD
displays one of the Call Failure status messages. (See
Table 3-3 in Chapter 3.)
If DTE dialing is enabled and any character is received
from the DTE before the modem goes online, the dial
sequence is aborted. This is known as any-key abort.
AT Command Equivalent
The
A
T command equivalent for Dial is DS=n, where n
is directory location 1–10.
Disconnect
Disconnect allows the modem to go on-hook (hang
up). Use this function when you want to disconnect an
established call on a dial line.
T
o access Disconnect from the Call Setup branch,
make the following selection:
F1
Call Setup: >
Dial Disconnect
F2
F3
Select
Disconnect.