Filter
Top Products
Call Setup Branch
5-53980-A2-GB30-20 November 1996
To
access Change Directory from the Call Setup
branch, make the following selections:
F1
Call Setup: >
Change_Directory
F2
F3
Press the
key until Change Directory is displayed.
Press any function key to select Change Directory
.
F1
01 : 5551234 ←
Nxt "#
F2
F3
The phone number listed in directory location 1 is
displayed. Select Nxt to display other directory locations.
Entering Telephone Numbers
and Dial Command Modifiers
into Directory Locations
The following example uses an empty directory
location for describing how to enter a telephone number.
If you want to change an existing telephone number in
any of the ten directory locations, follow the same
procedures.
To add a telephone number to a directory location,
make the following selections:
F1
02 : z
NxtąąąĄ"#
F2
F3
Select Nxt until a blank directory appears on the LCD.
(The cursor ( { ) always appears in the first character
position.)
Select F2 (") or F3 (#) until the desired character is
selected. This can be an alpha or numeric character.
F1
02 : 9 z
NxtąąąĄ"#
F2
F3
Press the key to move the cursor to the next
character position.
Continue this key sequence until the dial command
modifiers and telephone number are entered. (Refer to
Table 5-1 for an explanation of the dial command
modifiers available from the DCP.)
F1
01 : 9W5556789 z
NxtąąąĄ"#
F2
F3
To save the number just entered, scroll to the next
directory location by selecting Nxt. The number is now
stored in nonvolatile memory.
AT Command Equivalent
The
A
T command for Change Directory is & Zn=x,
where n is the directory location and x
is the telephone
number.
Table 5-1 describes what can be entered in directory
locations.