Filter
Top Products
Control Branch
10-53810-A2-GB30-20 November 1996
At this point, if you do not want to continue this
process, abort the transfer by selecting any function key.
This returns the modem to the Top-Level menu.
However, to continue with the transfer
, press the
key to display the Reprogram_Remote selection.
F1
Warning : Download
Reprogram_Remote
F2
F3
Press any function key to begin the transfer.
F1
RemClone Status
Establish Remote
F2
F3
The local modem’
s LCD displays
Establish Remote,
indicating the modem is attempting to establish a Remote
Cloning Download session with the remote modem.
If unsuccessful, the modem remains in the Download
Transfer mode. The LCD’
s top line displays
RemClone
Failed and the bottom line displays one of the following
messages:
Incompat
Modulat
The modems are connected,
but are using a modulation
scheme other than V
.33,
V
.32bis, V
.32, or V.29.
No Response
The remote modem is not a
3800 Series modem or the
connection between the two
modems is poor
.
Access
Disabled
The remote modem’
s Access
from Remote configuration is
disabled. Also is displayed if
the local modem has a
firmware release prior to
Release 3.0 and the remote
modem has Release 3.0 or
greater installed with either
Answer Access Security or
Originate Access Security
enabled. In this case, both
security methods must be
disabled in the remote modem
to achieve the download.
Password
Invalid
The local and remote
modems’ passwords do not
match.
Correct the problem and attempt another download
from the local modem. If this fails, contact your service
representative.
After successful establishment of a Remote Cloning
Download session, the following screens are displayed.
F1
RemClone Status
Initializing
F2
F3
F1
RemClone Status
Bank 1 : xxxx/yyyy
F2
F3