Filter
Top Products
DCP Operation
4-73810-A2-GB30-20 November 1996
Key
The key moves you up one level in the menu tree.
and
Keys
Use the
and
keys to move the viewing
window left or right and to scroll the remaining
branches and selections into view
. A maximum of
three selections can be displayed at one time.
These keys also allow you to move the cursor one
character to the left or right on data entry displays; for
example, to allow entry of one digit at a time.
F1, F2, F3 Keys
Function keys select the LCD choice that appears
above the function key; they are labeled F1, F2, and
F3. If a selection spans more than one function key,
then any of those keys choose that selection.
Select
Key (Model 381
1 only)
The
Select
key appears on the optional SDCP of the
COMSPHERE 3000 Series Carrier
. It is used to
connect the SDCP to a modem in a specific slot in the
carrier.
Menu Structure
The menu tree is a hierarchical structure used to
display functions that configure and control local and
remote 3800 Series modems. It is accessed via the DCP
and is shown in Appendix A.
The menu tree contains the following branches:
Call Setup
Used to dial, disconnect, and
answer telephone calls as well
as store up to 10 telephone
numbers in directory locations.
(See Chapter 5.)
Talk/Data
Used to switch the modem
between Talk mode (the
modem is disconnected from
the VF line) and Data mode
(the modem is connected to
the VF line) when dialing via
either the DCP or the attached
telephone. (See Chapter 6.)
Status
Used to monitor the current
status of the VF line and DTE
interface as well as view the
identity of the modem. (See
Chapter 7.)
Test
Used to begin and end various
modem tests. (See Chapter 8.)
Configure
Used to change and save the
modem’s configuration
options. (See Chapter 9.)
Control
Used to control the modem’s
hardware and software
functions. (See Chapter 10.)
Remote
Used to access and control a
remote 3800 Series modem.
(See Chapter 11.)
Security
Used to control the modem’s
dial access security
. Appears
only if the optional security
feature is installed. (See
Chapter 12.)
Menu tree branches are described in Chapters 5
through 12. Functions that appear on the LCD vary
depending upon the type of model installed, its operating
mode, and software configuration.
Tlk/Data Status Test Configure Control Remote
“Status”
494-13083-0
2
Call_Setup Security