Filter
Top Products
Index
Index-53810-A2-GB30-20 November 1996
Repeat Last Command (A/), 14-3
replacing modems, 2-8, 3-4
Reset, 10-2
Reset and Load Active (Z), 14-6
Reset Security, 12-10
Result Codes
Enable/Disable, 9-17
enable/disable, 14-5
extended, 14-6
format, 14-6
list, B-1
Result Codes Format, 9-18
rings before answer, 14-16
RS366A status, 7-4
RTS Action, 9-11, 14-10
RTS/CTS Delay, 9-12, 9-13
RTS/CTS Delay (S26), 14-17
S
S-registers, 14-15
change, 14-5
display, 14-5
format, 14-15
S0 (Auto-Answer Ring Number), 9-20, 14-16
S2 (AT Escape Character), 9-16, 14-16
S3 (Carriage Return Character), 9-16, 14-16
S4 (Line Feed Character), 9-17, 14-16
S5 (Backspace Character), 9-17, 14-16
S6 (Blind Dial Pause), 9-21, 14-16
S7 (No Answer Timeout), 9-21, 14-16
S8 (“,” Pause Time), 9-21, 14-17
S10 (No Carrier Disconnect), 9-23, 14-17
S12 (Escape Guard Time), 9-16, 14-17
S18 (Test Timeout), 9-40, 14-17
S26 (RTS/CTS Delay), 9-12, 14-17
S34 (1800 Hz Training Tone), 14-17
S35 (Auto Redial, Leased Line), 9-32, 14-18
S36 (Rate Auto Originate), 9-32, 14-18
S37 (Auto Redial, DTR), 9-24, 14-18
S38 (DTR Cont Repeat), 9-19, 14-19
S39 (Receive Buffer Disconnect Delay), 9-39, 14-19
S40 (Auto Make Busy), 9-24, 14-19
S41 (Dial Line Rate), 9-26, 14-19
S43 (V.32bis Train), 9-28, 14-20
S44 (Leased Line Rate), 9-29, 14-20
S45 (Leased Line Transmit Level), 9-30, 14-20
S46 (Bad Lines Auto Originate), 9-31, 14-20
S47 (Auto Dial Standby), 9-33, 14-21
S48 (Leased-Line Carrier On Level), 9-33, 14-21
S49 (Transmit Buffer Disconnect Delay), 9-38, 14-21
S51 (DTE Remote Loopback), 9-40, 14-21
S52 (DTE Local Loopback), 9-40, 14-21
S53 (V.54 Address), 9-41, 14-22
S54 (V.54 Device Type), 9-41, 14-22
S55 (Access from Remote), 9-43, 14-22
S56–S59 (Remote Access Password), 9-43, 14-22
S61 (CT111 Rate Control), 9-14, 14-22
S62 (V.25bis Coding), 9-18, 14-23
S63 (V.25bis Idle Character), 9-18, 14-23
S64 (V.25bis New Line Character), 9-19, 14-23
S65 (Line Current Disconnect), 9-22, 14-23
S66 (NMS Call Messages), 9-44, 14-23
S67 (Directory Location 1 Callback), 9-43, 14-23
S69 (Make Busy Via DTR), 9-24, 14-24
S74 (Network Position Identifier), 9-45, 14-24
S75 (Network Management Address), 9-44, 14-24
S76 (V.32bis Autorate), 9-27, 14-24
S77 (DTR Alarm Reporting), 9-44, 14-24
S78 (V.32bis Automode), 9-26, 14-24
S80 (No Data Disconnect Trigger Signal), 9-23,
14-25
S82 (V.32bis Autorate), 9-30, 14-25
S83 (MI/MIC Dialing), 9-25, 14-25
S84 (AT Command Mode), 9-18, 14-25
S85 (Fast Disconnect), 9-22, 14-25
S88 (Straps When Disconnected), 9-42, 14-26
S89 (V.42 ARQ Window Size Increase), 14-26
S90 (DTE Rate = VF Rate), 9-14, 14-26
S91 (Cellular Enhancements), 9-39, 14-26
S93 (Cellular RJ11 Adapt), 9-45, 14-26
save
configuration options, 14-11
telephone numbers, 14-11
SDCP (Shared Diagnostic Control Panel), 3-1
SDU (Shared Diagnostic Unit), 3-1
secondary channel, 11-2
Security branch, 12-4
Security configuration options, 9-46
security messages, 4-12
Self (Test branch), 8-2
self-test, 8-2
Send Break Control, 9-38
serial number, 14-5
Service Line, 10-3
Set Access Control, 12-5
Set Administrative Password, 12-10
Set Answer Security, 12-8
Set Originate Security, 12-9
setting factory defaults, 4-13
Speaker Control, 9-42, 10-2
Speaker On/Off (M), 14-5
Speaker Volume, 9-43
Speaker Volume (L), 14-5
status, 4-8
Status branch, 7-2
status indicators, 4-4
Stop Bits, 9-9
Store Telephone Numbers (&Z), 14-11
Straps When Disconnected, 9-42
Straps When Disconnected (S88), 14-26
Sync Mode (&M, &Q), 14-10