Filter
Top Products
7. Operation and Maintenance
9700-A2-GB20-20 December 2002 7-13
Router CLI Messages
The router’s Command Line Interface messages are listed alphabetically in
Table 7-4, CLI Messages. Refer to Appendix C,
Router CLI Commands, Codes,
and Designations
, for show commands and additional information.
Table 7-4. CLI Messages (1 of 5)
Message What It Indicates
% Access list entry already exists An attempt was made to add an already existing
access list rule.
% Access list does not exist An attempt was made to delete a non-existent
access list.
% Access list is not assigned An attempt was made to delete a non-existent
access list assignment.
% Access list number must be
between 1 and 299
The access list number entered is outside the valid
range.
% Access list number must be
between 200 and 299
The access list number entered to create a bridge
filter rule is outside the valid range.
% Administrator level access is
required for this command.
An attempt was made to access configuration
information without the authorized access level.
% ARP Timeout can only be
specified on the Ethernet port
An attempt was made to specify the ARP timeout
on an interface other than the Ethernet port.
% ARP Timeout must in the range
0–4294967
An attempt was made to specify an ARP timeout
that is outside the valid range.
% Bridge group filter already exists An attempt was made to create an already existing
bridge filter rule.
% Bridge group filter does not exist The bridge group filter specified for deletion does
not exist.
% Bridge group filter list is full An attempt was made to add a bridge filter rule, but
the maximum number of rules have already been
created.
% Bridge group not assigned An attempt was made to remove a non-existent
bridge group assignment.
% Destination IP address is already
part of an interface route
The route entered for a destination IP address is
within the IP address range assigned to the
interface.
% DHCP max clients must be
1–
MaximumDHCPClients
An attempt was made to enter an invalid DHCP
client limit.
% DHCP network does not exist An attempt was made to delete a non-existent
DHCP network.
% DHCP Network Prefix range
1–32
An attempt was made to enter an invalid prefix
length.
% DHCP pool does not exist An attempt was made to delete a non-existent
DHCP pool.