Filter
Top Products
4. Configuration Options
4-4 December 2002 9700-A2-GB20-20
Table 4-1. Easy Install Configuration Options (1 of 4)
DSLAM Type (9783)
Possible Settings: Paradyne, Alcatel (NewBridge), PairGain, Nokia
Default Setting: Paradyne
Ensures interoperability with non-Paradyne DSLAMs, not just the Hotwire GranDSLAM.
This option is only available from the Easy Install screen.
NOTES:
– The default is set before the unit is shipped, based upon the CLEC customer
ordering the unit. If you change the default, you must S
ave the change for it to take
effect, which will reset the unit.
– When the default is changed, the default settings for other configuration options
change. See
Network 1 DSL Line Rate (9783)
on page 4-6,
DSL Line Rate (Kbps)
on page 4-21, and
Cell Payload Scrambling
on page 4-27 for more information.
Paradyne – The FrameSaver device is used with a Hotwire GranDSLAM.
Alcatel (NewBridge) – The FrameSaver device is used with Alcatel’s NewBridge DSLAM.
PairGain – The FrameSaver device is used with PairGain’s DSLAM.
Nokia – The FrameSaver device is used with Nokia’s DSLAM.
Node IP Address
Possible Settings: 001.000.000.000–126.255.255.255,
128.000.000.000–223.255.255.255, Clear
Default Setting: Clear (000.000.000.000)
Specifies the IP address needed to access the node. Since an IP address is not bound to
a particular port, it can be used for remote access via a management PVC.
001.000.000.000 – 223.255.255.255 – Shows the IP address for the node, which can be
viewed or edited. The first octet of the address cannot be decimal 0 or 127, or greater than
223.
Clear – Fills the node IP address with zeros.
Node Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the IP address subnet mask that is needed to access the node. Since the
subnet mask is not bound to a particular port, it can be used with the Node IP address for
remote access via a management PVC.
000.000.000.000 – 255.255.255.255 – Shows the subnet mask for the node, which can be
viewed or edited.
Clear – Fills the node subnet mask with zeros. When the node’s subnet mask is all zeros,
the IP protocol creates a default subnet mask based upon the IP address class
(Class A: 255.000.000.000, Class B: 255.255.000.000, or Class C: 255.255.255.000).