C. Router CLI Commands, Codes, and Designations
C-10 December 2002 9700-A2-GB20-20
[no] bridge-group
bridge-group
Minimum Access Level: Administrator
Command Mode: config-if, config-subif
Allows a user to apply or remove a set of bridge group parameters to/from an interface or
sub-interface. When a set of bridge group parameters is applied or removed at the
interface level, the command also applies to all sub-interfaces on the interface.
Example: no bridge-group
NOTE: If the bridge group is only required on specific sub-interfaces, remove the
bridge group from an interface and apply it at the sub-interface level.
bridge-group
– Valid bridge group number 1 is applied to all interfaces by default. Any
sub-interfaces created on interfaces where the bridge group is applied inherit the bridge
group.
[no] bridge-group
bridge-group
{input-type-list
in-access-list-200num
|
output-type-list
out-access-list-200num
}
Minimum Access Level: Administrator
Command Mode: config-if
Allows a user to specify or remove an input or output Ethernet type code filter for an
interface. No bridge group filters are applied to interfaces by default.
Example: bridge-group 1 input-type-list 8069
NOTE: The order in which access-list filters are entered affects the order in which the
filters are applied. Each filter is applied in succession until all filters have been applied.
If no conditions match, a frame is discarded.
bridge-group
– Valid bridge group number 1 is applied to all interfaces by default. Any
sub-interfaces created on interfaces where the bridge group is applied inherit the bridge
group.
input-type-list – Specify the filter applied to incoming Ethernet packets by type code.
Refer to Table C-14, Ethernet Type Codes (Hex).
in-access-list-200num
– The input type access list valid range for protocol type-code
access lists: 200–299.
output-type-list – Specify the filter applied to outgoing Ethernet packets by type code.
Refer to Table C-14, Ethernet Type Codes (Hex), Ethernet Type Codes (Hex).
out-access-list-200num
– The output type access list number valid range for protocol
type-code access lists: 200–299.
Table C-6. Bridge Commands (2 of 2)