Filter
Top Products
4. Configuration Options
9700-A2-GB20-20 December 2002 4-53
Configuring SNMP Traps
Select SNMP Traps from the Management and Communication menu to configure
SNMP traps when a trap is generated (see Table 4-23, SNMP Traps Options).
Main Menu Configuration Management and Communication
SNMP Traps
See Appendix B,
SNMP MIBs, Traps, and RMON Alarm Defaults
, for trap format
standards and special trap features, including RMON-specific traps, and the
default settings that will generate RMON-specific SNMP traps.
Table 4-23. SNMP Traps Options (1 of 4)
SNMP Traps
Possible Settings: Enable, Disable
Default Setting: Disable
Determines whether the FrameSaver unit sends trap messages to the currently
configured SNMP trap manager(s).
Enable – Sends trap messages.
Disable – Does not send trap messages.
Number of Trap Managers
Possible Settings: 1 – 6
Default Setting: 1
Specifies the number of SNMP management systems that will receive SNMP trap
messages from the FrameSaver unit. For each trap manager to receive trap messages, an
NMS IP Address must be configured in the NMS
n
IP Address configuration option (next
option).
1 – 6 – Specifies the number of trap managers.
NMS
n
IP Address
Possible Settings: 001.000.000.000–126.255.255.255,
128.000.000.000–223.255.255.255, Clear
Default Setting: Clear (000.000.000.000)
Specifies the IP address that identifies the SNMP manager(s) to receive SNMP traps.
Display Conditions
– This option appears for each trap manager specified in the
Number of Trap Managers configuration option.
001.000.000.000 – 223.255.255.255 – Adds to or changes the IP address for the trap
manager. The first octet of the address cannot be decimal 0 or 127, or greater than 223.
Clear – Fills the NMS IP address with zeros.