Filter
Top Products
7. Operation and Maintenance
7-14 December 2002 9700-A2-GB20-20
% DLCI number must be 16–1007 The DLCI entered is not in the valid range.
% Frame-Relay encapsulation is
only supported on Serial ports
An attempt was made to enable frame relay
encapsulation on the Ethernet port.
% For Ethernet ports, interface
must be 0
An unsupported interface index was entered for the
Ethernet port.
% For Serial ports, interface must
be 0
An unsupported interface index was entered for the
serial port.
% Gateway of last resort is not set No Gateway of last resort was configured.
% ICMP Message type and code
combination not supported
The ICMP message type/code combination entered
is not supported by the product.
% ICMP Message type must be
0–255
The ICMP message type entered is not within the
valid range.
% ICMP Message code must be
0–255
The ICMP message code entered is not within the
valid range.
% Invalid IP address or Mask
specified
The prefix length entered is not valid for the
start-ip-address
or
end-ip-address
.
% Invalid sub-interface specified The sub-interface specified for deletion does not
exist.
% IP Address already in use for
device management
An attempt was made to reassign the Ethernet
port’s or node’s IP address, but the address is being
used.
% IP Address cannot be removed,
since a static route relies on it
An attempt was made to delete an interface
address assignment that has routing table entries
other than an interface route, with Next Hop Router
addresses that fall within its address range.
% IP Address does not exist in ARP
table
An attempt was made to delete an ARP entry for an
IP address, but no ARP entry exists for the specified
address.
% Lease must be 0–365 days,
0–24 hours, 0–59 minutes
An invalid lease time was entered.
% Maximum number of access lists
exceeded
An attempt was made to add an access list, but the
maximum number of access lists have already been
created.
% Maximum number of access list
assignments to interface exceeded
An attempt was made to add an access list
assignment, but the maximum number of access
lists have already been assigned to the interface.
% Maximum number of filters
exceeded on this access list
An attempt was made to add an access list filter
rule, but the maximum number of filter rules have
already been created.
% Maximum number of NAT pools
reached
An attempt was made to add a NAT pool, but the
maximum number of pools have already been
reached.
Table 7-4. CLI Messages (2 of 5)
Message What It Indicates