Filter
Top Products
SV61891 Rev. A 3-11
DM230L, DM330L, DM350L Operating Guide
1. From the Ready screen on the
IntelliLink
TM
Control Centre, rate your
mail piece by weighing it on the optional
weigh platform or by entering the weight
manually (press Class and then select
Manual Weight Entry). Then select a
class for the mail piece and any desired
special services.
2. Press the Tape key.
3. The system display prompts you to
enter the number of tape strips you
want to print.
4. Key in the number you want. You can
enter a number ranging from 1 up to a
maximum of 50.
5. Press the Enter key. The system automatically feeds and prints the
number of tapes you entered with the postage value you selected.
The display says “Printing Tape...” and shows the number of tapes
remaining to print.
NOTE: The DM230L does not have a Tape Strip dispenser. In order to process
a parcel you must use a Tape Sheet which is run throught the feeder like an
envelope. To order Tape Sheets refer to Chapter 8 – Supplies and Options.
Printing
Postage on
Tape Sheets
and Tape
Strips
The procedures for printing postage on tapes strips are different for the
DM230L/DM330L and the DM350L systems. Refer to the appropriate
procedure in this section.
DM230L/
DM330L:
Printing Tapes
Load tape strips blank
side up; push them into
the feeder as far as they'll
go. You'll feel a slight re-
sistance before they're all
the way in.
Use tape strips to apply postage to larger envelopes or parcels. You can
print tape strips one at a time or in batches of up to 50. If you need to load
tape strips, see Chapter 6 in this guide.
2