Filter
Top Products
FCC Compliance of Modem
This equipment complies with Part 68 of the FCC rules and the requirements adopted by ACTA. On the top
of the control centre of this equipment is a label that contains, among other information, a product identifier in
the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. The
equipment is designed to connect to a two-wire, local switch, access loop start (Facility Interface Code 02LS2)
with a standard RJ-11 interface.
The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENs should not exceed five. To be certain of the number of devices that may be
connected to the line, contact the telephone company to determine the maximum REN for your calling area.
The REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits
represented by ## are the REN without a decimal point (for example 03 is a REN of 0.3).
If this modem causes harm to the telephone network, the telephone company may discontinue your service
temporarily. You will be notified in advance or as soon as possible. You will be advised of your right to register
a complaint with the FCC. If the user experiences trouble using this equipment, the user shall disconnect the
equipment from the telephone line to determine if the equipment is malfunctioning. If the equipment is malfunc-
tioning, the use of the equipment shall be discontinued until the problem is corrected.
The telephone company may make changes to its facilities, equipment operations, or procedures that could
affect the operation of this equipment. In this event, the telephone company will provide advance notice for you
to make necessary modifications to maintain uninterrupted service.
If you experience trouble with this modem, please refer to the warranty information provided with this equip-
ment. If the trouble is causing harm to the network, the telephone company may request that you remove the
equipment from the network until the problem is resolved.
This equipment may not be used with party lines or coin lines.
This equipment is not intended to be serviceable. Please refer to the warranty information if problems occur.
Failed units will be withdrawn by approved Pitney Bowes service engineers and returned to the U.S. Ser-
vice Centre. For reference purposes, the U.S. Service Centre contact address is: Pitney Bowes Inc., Walter
Wheeler Drive, Stamford, CT 06926-0700.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements adopted by ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is
also compliant. See installation instructions for details. If the installation site has specially wired alarm equip-
ment connected to the telephone line, ensure the installation of this equipment does not disable the alarm
equipment. If you have questions about what will disable alarm equipment, consult your telephone company or
a qualified installer.