Filter
Top Products
RealPresence Collaboration Server 800s Administrator’s Guide
16-34 Polycom, Inc.
In Multiple Networks mode, the resources of the Network Services are not split between the
network services but are used per their availability by all Network Services equally.
First Time Installation and Configuration
First Time Installation and Configuration of the RealPresence Collaboration Server 800s consists of
the following procedures:
1 Preparations
— Gather Network Equipment and Address Information - get the information needed
for integrating the Collaboration Server into the local network for each of the
networks that will be connected to the Collaboration Server unit. For a list of
required address, see the RealPresence Collaboration Server 1800 Getting Started
Guide, "Gather Network Equipment and Address Information” on page 2-1.
— Unpack the Collaboration Server. For more details see the Polycom® RealPresence
Collaboration Server 800s Getting Started Guide, Chapter 2.
— Modify the Management Network parameters on the USB Key. For more details see
the Polycom® RealPresence Collaboration Server 800s Getting Started Guide, "Modifying
the Factory Default Management Network Settings on the USB Key” on page 2-6.
2 Hardware Installation and Setup
— Mount the Collaboration Server in a rack. For more details see the Polycom®
RealPresence Collaboration Server 800s Getting Started Guide, "” on page 2-3.
— Connect the necessary cables. For details, see Polycom® RealPresence Collaboration
Server 800s Getting Started Guide, "” on page 2-3.
3 First Entry Power-up and Configuration
— Power up the Collaboration Server. For more details see the Polycom® RealPresence
Collaboration Server 800s Getting Started Guide, "Procedure 1: First-time Power-up” on
page 2-8.
— Register the Collaboration Server. For more details see the Polycom® RealPresence
Collaboration Server 800s Getting Started Guide, "Procedure 2: Product Registration” on
page 2-8.
— Connect to the
Collaboration Server.
For more details see the Polycom® RealPresence
Collaboration Server 800s Getting Started Guide, "Procedure 3: Connection to MCU” on
page 2-9.
— Configure the Default IP Network Service using the information for one of the
networks connected to the system . For more details see the Polycom® RealPresence
Collaboration Server 800s Getting Started Guide, "Procedure 4: Modifying the Default IP
Service Settings” on page 2-11.
4 Modify the required System Flag to enable Multiple Services and reset the MCU.
5 Add the required IP Network Services to accommodate the networks connected to the
Collaboration Server.
6 Select a Network Service to act as default for dial out and gateway calls for which the
Network Service was not selected.
7 Place several calls and run conferences to ensure that the system is configured
correctly..
.