Filter
Top Products
Psion Teklogix 9160 G2 Wireless Gateway User Manual 125
Chapter 11: Maintenance And Monitoring
Transmit/Receive Statistics
This page provides some basic information about the current access point and a real-
time display of the transmit and receive statistics for this access point as described in
Table 11.2 on page 125. All transmit and receive statistics shown are totals since the
access point was last started. If the AP is rebooted, these figures indicate trans-
mit/receive totals since the re-boot.
Field Description
IP Address
IP Address
for the access point.
MAC Address
Media Access Control (
MAC
) address for the specified interface.
A MAC address is a permanent, unique hardware address for any device that represents an inter-
face to the network. The MAC address is assigned by the manufacturer.
The 9160 G2 Wireless Gateway has a unique MAC address for each interface. A two-radio access
point has a different MAC address for each interface on each of its two radios.
VLAN ID
Virtual
LAN
(
VLAN
) ID.
A VLAN is a software-based, logical grouping of devices on a network that allow them to act as if
they are connected to a single physical network, even though they may not be.
VLANs can be used to establish internal and guest networks on the same access point.
Name (SSID)
Wireless network name. Also known as the
SSID
, this alphanumeric key uniquely identifies a wire-
less local area network.
The SSID is set on the Basic Settings tab. (See “Provide Network Settings” on page 49.)
Transmit and Receive Information
Total Packets
Indicates total packets sent (in Transmit table) or received (in Received table) by this access point.
Total Bytes
Indicates total bytes sent (in Transmit table) or received (in Received table) by this access point.
Errors
Indicates total errors related to sending and receiving data on this access point.
Table 11.2 Transmit/Receive Statistics