Q-Logic 59060-02 B Switch User Manual


 
3 – Event Messages
Alarm Events
59060-02 B 3-17
A
(A1004.0043) (Forcing Domain ID change due to Interoperability setting from
old_domain_ID to new_domain_ID.)
Meaning: The Domain ID of the switch is changed due to an interoperability
configuration change. The old Domain ID does not conform to the
range of allowed Domain IDs for the new interoperability setting.
Action: None.
(A1004.0048) (Eport Isolating due to Port Binding failure)
Meaning: A switch device attempted to login as an ISL, but that device was
not configured in the port binding list.
Action: Add the device to the port binding list.
(A1004.0049) (Eport Isolating due to Remote inactive)
Meaning: The remote switch is unresponsive and the link has not been
brought up. The port will be isolated because the remote switch
failed to respond.
Action: Investigate the remote switch.
(A1004.0050) (Maximum hard zoning member limit exceeded, Reverting to soft zoning.
Requires port reset.)
Meaning: The maximum number of zone members associated with a port is
limited to 64. If this number is exceeded, the switch cannot enforce
hard zoning and will revert to soft zoning.
Action: Reduce the number of zone members associated with the port and
reset the port.
(A1004.0051) (Blade IO blade_number isolated due to startup problem)
Meaning: There is an internal communication issue with an IO blade. It will
be set down until it clears.
Action: If this problem persists, contact your authorized maintenance
provider.
(A1004.0052) (Eport Isolating due to Switch Binding failure)
Meaning: A device attempted to login as an ISL, but that device was not
configured in the switch binding list.
Action: Add the device to the switch binding list.
(A1004.0053) (Adding Denial of Service entry for source FC Address 0xaddress)
Meaning: A number of frames from the indicated address have been
received. These frames are from a source that is not zoned with
the destination. A denial of service entry will be set up to discard
these frames.
Action: Investigate the source at the specified FC address.