3 – Event Messages
Alarm Events
3-26 59060-02 B
S
(A1007.0027) (Radius server could not validate authentication response from port_number)
Meaning: RADIUS authentication failed.
Action: Confirm that the secret is the same on the switch as it is on the
RADIUS server.
(A1007.0028) (Security: 2-Way Authentication, No security entry found for port)
Meaning: Unable to locate a security member entry to complete a two way
authentication.
Action: Edit the group to include the port.
(A1007.0029) (Security protocol not using chap, unable to authenticate.)
Meaning: A CHAP negotiate frame was received that specifies an
unsupported authentication protocol.
Action: Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable CHAP for this device
if it belongs in the fabric.
(A1007.002A) (Inconsistent Fabric Binding configuration. Enabled on remote switch(s),
disabled on local switch.
Meaning: Inconsistent fabric binding configuration settings between local and
remote switch. All switches in fabric must have the same
configured fabric binding setting.
Action: Enable or disable fabric binding on all switches.
(A1007.002B) (Security: Chap session Negotiate Authentication failed)
Meaning: Local switch received an authentication negotiate frame which
failed processing. Either the payload of the frame did not match the
standard layout of the frame or the CHAP session between the
devices being authenticated was not in the state where the
negotiate frame was expected.
Action: Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable CHAP for this device
if it belongs in the fabric.
(A1007.002C) (Security: Authentication protocol msg (AUTH_DONE) inconsistent with
Authentication protocol in progress)
Meaning: The local switch received a AUTH_DONE command authentication
frame while the chap session was not in the correct state to expect
this type of frame. Remote device is not following standard
authentication protocol.
Action: Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable CHAP for this device
if it belongs in the fabric.