Q-Logic 59060-02 B Switch User Manual


 
3 – Event Messages
Critical Events
59060-02 B 3-39
A
(C) (8400.0069) (Switch) (Warning-When leaving the Diagnostics AdminState of the
primary CPU blade, an automatic reset of the blade will occur. The blade and
the switch will come back up in the configured AdminState.)
Meaning: The primary CPU blade is entering Diagnostics state and will
automatically undergo a hard reset. The I/O blade will return to the
configured administrative state after leaving the Diagnostics
administrative state.
(C) (8400.006A) (Switch) (Upgrading License for Fabric Security)
Meaning: The Fabric Security Bundle license was applied successfully.
(C) (8400.006B) (Switch) (Upgrading License for CLI Extended Credits capability)
Meaning: The CLI Extended Credits license was applied successfully.
(C) (8600.0009) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port
port_number.)
Meaning: The port will perform a link reset (LR) due to loss of credit issue.
(C) (8600.000A) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port
port_number.)
Meaning: The port will perform a link reset (LR) due to loss of credit issue.
(C) (8600.000B) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port
port_number.)
Meaning: The port will perform a link reset (LR) due to loss of credit issue.
(C) (8600.0013) (PortApp) (Invalid vendor data from media device for port port_number)
Meaning: The switch could not read and verify the media module ID. This
may indicate a discovery error or a bad checksum in the serial ID.
Other possibilities include an improperly installed media module or
an internal media I/O hardware fault.
(C) (8600.0014) (PortApp) (Invalid vendor data from media device for port port_number)
Meaning: Switch could not read and verify the media module ID. This could
be caused by a media discovery error, a bad checksum in the
media serial ID, an improperly installed media, or an internal media
I/O hardware fault.
(C) (8600.0015) (PortApp) (Unresponsive device alpa on port port_number removed from
the fabric.)
Meaning: A device on the loop port did not take a OPN off the loop destined
for it. This suggests either the device has been physically removed
or is faulty. It has been removed from the fabric nameserver.