Filter
Top Products
Paper and Other Media Supported by Your Printer
37
4
❖
OHP Transparencies
• If you load OHP transparencies onto Bypass Tray Type 270, set the printer
to "Transparency" mode using the printer driver.
• Be careful not to touch the print side of the OHP transparencies. Other-
wise, the print side can become dirty or damaged, resulting in poor print
quality.
• If you print on an OHP transparency that has a print side, load it face up
onto tray 2 or load it face down onto Bypass Tray Type 270.
• Do not print on OHP transparencies for color.
❖
Adhesive Labels
• Load only one adhesive label at a time onto Bypass Tray Type 270.
• Use adhesive labels in which the whole side can be printed on.
• Avoid using adhesive labels having exposed glue.
• If the print side is coated, the print quality might be reduced, as the toner
might not fuse well.
❖
Envelopes
• When printing on envelopes, use tray 2 or Bypass Tray Type 270.
• You can specify the sizes for the envelopes using the operation panel.
⇒ P.94 “Job Control Parameters”
• Recommended of envelopes is as follows:
• Com#10 Env
•C6 Env
•C5 Env
• DL Env
• Monarch Env
• Do not stack envelopes over the limit mark.
• Confirm that print side is facing up when loading onto the tray 2.
• Confirm that print side is facing down when loading onto Bypass Tray
Type 270.
• Load the envelopes with the flaps aligned to the right side fence. The flaps
should be securely folded down.
• Confirm that there is no air in the envelopes before loading.
• To get better print quality, it is recommended that you set the right, left,
top, and bottom print margins, to at least 15mm (0.6") each.
• Do not print on both sides of envelopes.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten the leading edges (side being fed into the
printer) of them by running a pencil or ruler across them.