Filter
Top Products
Printer Doesn't Print
65
5
Note
❒
The following procedure describes the printer port settings.
•
Windows 95/98
A Click
[
Start
]
, point to
[
Settings
]
, and then click
[
Printers
]
.
B Click the icon of the printer. Next, on the
[
File
]
menu, click
[
Properties
]
.
C Click the
[
Details
]
tab.
D Check the
[
Print to the following port:
]
list to confirm the correct port is se-
lected.
•
Windows NT 4.0
A Click
[
Start
]
, point to
[
Settings
]
, and then click
[
Printers
]
.
B Click the icon of the printer. Next, on the
[
File
]
menu, click
[
Properties
]
.
C Click the
[
Port
]
tab.
D Confirm that the correct port is selected.
•
Windows 3.1x
A On
[
Control Panel
]
, double-click the
[
Printers
]
icon.
B Confirm that this printer is specified as the default printer.
C Click
[
Connect
]
.
D Check the
[
Ports
]
list to confirm the correct port is selected.
•
Macintosh
A Click
[
Apple Menu
]
, point to
[
Control Panels
]
, and then select
[
Apple Talk
]
.
B Confirm that
[
Ethernet
]
is selected in the
[
connect via:
]
list.
Is the
Data In
indicator
blinking or lit after start-
ing the print job, when
using the PCL printer?
If not, the data is not being sent to the printer, or the printer
may be resetting the print job because there was a long de-
lay in receiving the data from the computer.
❖
If the printer is using "I/O Timeout"
Increase the value of the "I/O Timeout" setting of the
"System" menu of the "Job Control".
⇒
P.89 “Using the
Operation Panel”
❖
If your printer is connected to the computer using the
parallel cable
Confirm that the printer port settings are correct. For a
parallel port connection, port LPT1 or LPT2 should be
set.
For more information on the printer port settings, see the
Note after this table.
❖
Network Connection
Contact your network administrator.
Possible Cause Solutions