Filter
Top Products
107
CONFIGURING WITH A LOCAL CONSOLE
The prompt
Console Baud : [9600]
will appear.
The default of Console Baud is 9600.
Pressing the spacebar on the keyboard will toggle to the next
setting in the sequence (9600, 4800, 2400, 1200, 19200).
Choices:
• Press the spacebar to select a different console baud rate.
• Do one of the following:
• Leave this feature unchanged by not
pressing the spacebar, or if you have already
pressed the spacebar, reselecting the original
baud rate again.
• Change the setting by pressing the spacebar.
Press the Enter key when you are ready to continue.
The following message will appear:
Is the above setup information correct? (y/n) -
Type n to start over with this section.
Type y to use the current settings. While the settings will be
used by the router, they are not actually saved. To save the
settings, you must select SAVE from the command prompt of
the OverLAN Operating System.
This completes Task 1 of Configuring with a Local Console.