Filter
Top Products
60
Current Address/Networks to Filter Out
This is a table of IP addresses that OverLAN Commander uses to
filter out packets coming from those addresses. IP Addresses can
specify a single node or an entire network. There are three
columns of information indicated in the table. These columns are
described below.
Type: This column indicates whether an Address (a specific node
of a network) or a Network (a range of addresses) is being filtered
out.
Address/Network: This column indicates the IP Address being
filtered out. If the IP Address ends in a zero, then the address
represents the local host address.
Subnet Mask: This column indicates the Subnet Mask if the Type
column indicates a Network. For a node specific address, this
column shows "---.---.---.---" for the Subnet Mask.
Address/Network to Filter Out
This section of the dialog box is where you specify IP Addresses to
be filtered out.
Type: From the drop-down list, specify whether an Address (a
specific node of a network) or a Network (a range of addresses) is
to be filtered out.
Address/Network: In this data field, specify the IP Address that
is to be filtered out. Type the IP Address in the form of
xxx.xxx.xxx.xxx, where each xxx is a number ranging from 1 to
255.
CONFIGURING YOUR ROUTER