Filter
Top Products
109
The prompt
Call Type : [By Command]
will appear beneath the previous prompt.
The default of Call Type is By Command. Pressing the
spacebar switches between the available settings.
Choices:
• By Command is used when you want calls to be manually
placed. In this setup, the router cannot place calls
automatically.
• On Demand instructs the router to place calls
automatically when data is received for the remote
network. When On Demand is selected, Bandwidth on
Demand is automatically enabled (if PPP Multilink is
enabled).
• When one or both B-channels are selected as Permanent
Channels, then the selected channel(s) will remain open all
of the time. If an error causes a disconnection, the router
will automatically redial the number and raise the line up
again.
When only B1 or B2is a permanent channel (unless you also
have PPP Multilink and Bandwidth on Demand enabled),
then any calls or hangups on the remaining (nonpermanent)
B-channel must be performed manually.
Press the Enter key when you are ready to continue.
CONFIGURING WITH A LOCAL CONSOLE