Filter
Top Products
7
Installing the OverLAN Router
Task 1: Connecting the router to an Ethernet
network using one of the following methods:
METHOD 1: 10BASE-T
Step 1:
Connect one end of a shielded RJ45 cable into the
10BASE-T interface on the back of the router -- see
figure 1.
Figure 1
Step 2:
Connect the other end of the cable into the 10BASE-T
interface on the hub of the Ethernet -- see figure 1.
Always use a HUB in a 10baseT environment to connect
your ISDN Router to the network. NOTE: Do not use
crossover cable.
This completes Task 1.
INSTALLING the OverLAN ROUTER
Hub must be
installed before the
router can be
installed.
Ethernet Hub
10BASE-T Interface
Back of Router
Shielded
RJ45 cable
Serial
ISDN Line
10base2
Power
Reset