Filter
Top Products
160
O v e r L A N
System Operations menu
1. - Revert to Permanent OverLAN System
2. - Erase All Setup Information
3. - Perform ISDN Loopback Test
Selection:
To place a call, use the CALL x command. Type either
CALL or C followed by a 1, 2, or M where 1 represents
channel B1, 2 represents channel B2 ,and M represents
multilinking (both channels). Press Enter when you are
ready.
To close a channel, use the CLOSE command. Type either
CLOSE or CL. This command closes both channels if both
channels are open or, if only one channel is open, closes
whichever channel is open. Press Enter when you are ready.
To restart the router and end all calls, use the RESET
command. Type either RESET or RE and press Enter when
you are ready.
To configure the router, use the SETUP command. Type
either SETUP or SU and press Enter when you are ready.
For more information on configuring the router, see the
Configuring Your Router section of the manual.
To enter the OverLAN Systems Pptions menu, use the
SYSOP command. Type either SYSOP or SY and press
Enter when you are ready. The SYSOP Menu is shown
below.
OPERATING YOUR ROUTER