Filter
Top Products
Regulatory information_ 6
You should also know that:
• Your machine is not designed to be connected to a digital PBX system.
• If
you intend to use a computer modem or fax modem on the same phone line as your machine, you may experience transmission and
reception problems with all the equipment. It is recommended that no other equipment, except for a regular telephone, share the line with
your machine.
• If
your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for both the power
and the telephone lines. Surge protectors can be purchased from your dealer or telephone and electronic specialty stores.
• Whe
n programming emergency numbers and/or making test calls to emergency numbers, use a non-emergency number to advise the
emergency service dispatcher of your intentions. The dispatcher will give you further instructions on how to actually test the emergency
number.
• Thi
s machine may not be used on coin service or party lines.
• Thi
s machine provides magnetic coupling to hearing aids.
You may safely connect this equipment to the telephone netwo
rk by means of a standard modular jack, USOC RJ-11C.
Replacing the Fitted Plug (for UK Only)
Important
The mains lead for this machine is fitted with a standard (BS 1363) 13 amp plug and has a 13 amp fuse. When you change or examine the
fuse, you must re-fit the correct 13 amp fuse. You then need to replace the fuse cover. If you have lost the fuse cover, do not use the plug until
you have another fuse cover.
Contact the people from you purchased the machine.
The 13 amp plug is the most widely used type in the UK and should be suitabl
e. However, some buildings (mainly old ones) do not have normal
13 amp plug sockets. You need to buy a suitable plug adaptor. Do not remove the moulded plug.
If you cut off the moulded plug, get rid of it straight away.
You cannot rewire the plug and you may receive an electric shock if
you plug it into a socket.
Important warning:
You must earth this machine.
The wires in the mains lead have the following color code:
• G
reen and Yellow: Earth
• Blue: Neutral
• Brow
n: Live
If the wires in the mains lead do not match the colors marked in your plug, do the following:
You must connect the green and yellow wire to the pin marked by the
letter “E” or by the safety ‘Earth symbol’ or colored green and yellow or
green.
You must connect the blue wire to the pin which
is marked with the letter “N” or colored black.
You must connect the brown wire to the pin which is marked with th
e letter “L” or colored red.
You must have a 13 amp fuse in the plug,
adaptor, or at the distribution board.