Filter
Top Products
Network setup_ 1
1.network setup
This chapter gives you step-by-step instructions for setting up the network connected machine and software.
This chapter includes:
• Network environment
• Introducing useful network programs
• Using a wired network
• Installing network connected machine’s driver
• IPv6 Configuration
Network environment
You need to set up the network protocols on the machine to use it as your
network machine. You can set up the basic network settings through the
machine's control panel.
The following table shows the network en
vironments supported by the
machine:
Item Requirements
Network interface • Ethernet 10/100 Base-TX
• 802.11
b/g Wireless LAN (Optional)
Network operating system • Win
dows
2000/XP/2003/2008/Vista/7/2008
Server R2
• Variou
s Linux OS
• Ma
c OS X 10.3 ~ 10.6
• UNIX
Network protocols • TCP/
IPv4
• DHCP, BOOTP
• DNS, WINS, Bo
njour, SLP, UPnP
• Stan
dard TCP/IP Printing (RAW), LPR,
IPP, WSD
• SNMPv 1/2/3, HTT
P (S), Telnet, SMTP
(S), LDAP (S), IPSec
• SM
B, FTP, Kerberos
• TCP/IPv6
(DHCP, DNS, RAW, LPR,
SNMPv 1/2/3, HTTP (S), IPSec)
(See "IPv6 Configuration" on page 6.)
Wireless security
(Op
tional)
• Authentication: Open System, Shared
Key, WPA Personal, WPA2 Personal
(PSK)
• Encryp
tion: WEP64, WEP128, TKIP,
AES
Introducing useful network programs
There are several programs available to setup the network settings easily in
network environment. For the network administrator especially, managing
several machines on the network is possible.
Before using the programs below, set the IP address first.
SyncThru™ Web Service
Web server embedded on your network machine, which allows you to:
• C
onfigure the network parameters necessary for the machine to connect
to various network environments.
• Custom
ize machine settings.
(See "Using SyncThru™ Web Service" on page 1.)
SyncThru™ Web Admin Service
A web-based machine management solution for network administrators.
SyncThru™ Web Admin Service provides you with an efficient way of
managing network devices and lets you remotely monitor and troubleshoot
network machines from any site with co
rporate internet access. Download
this program from http://solution.samsungprinter.com.
SetIP
This utility program allows you to select a network interface and manually
configure the IP addresses for use with the TCP/IP protocol (See "IPv4
setting using SetIP Program (Windows)" on page 2 , "IPv4 setting using
SetIP Program (Macintosh)" on page 2 or "IPv4 setting using SetIP Program
(Linux)" on page 3).
TCP/IPv6 is not supported by this program.
Using a wired network
You must set up the network protocols on your machine to use it on your
network. This chapter will show you how this is easily accomplished.
You can use network after connecting network cable to a corresponding
port on your machine.
Printing configuration report
You can print a Network Configuration Report from the machine’s control
panel that will show the current machine’s network settings. This will help
you to set up a network and troubleshoot problems.
1. Pres
s Menu on the control panel.
2. Pre
ss the up/down arrow to highlight System Setup and press OK.
3. Pre
ss the up/down arrow to highlight Report and press OK.
4. Pre
ss the up/down arrow to highlight Network Info. and press OK.